Hi Heidi,
Thanks for the photos. They show exactly what happened. You’re right that there’s no set screw at that end. The handle bar on your RF265ABPN is a hollow aluminum tube, and each end slips over a molded end post that comes out of the mounting block on the drawer. At the factory that joint is held by a snug fit plus adhesive. After 12+ years of people pulling a heavy freezer drawer open, the glue on the right end gave up and the tube slid off the post.
Can it be fixed?
Yes. Re-gluing is a fair fix, as long as the parts themselves aren’t damaged. Before you glue, check two things:
- The end post. Look it over for cracks or chipped edges. If it’s cracked, glue won’t hold for long.
- The left end. Wiggle it. If it’s loose too, glue both ends now so you don’t have to do this again next month.
How I’d re-glue it
- Scrape all the old adhesive off the end post and out of the tube. A small flat screwdriver or a utility blade works, but go easy on the plastic.
- Lightly scuff both surfaces with medium sandpaper, then wipe them with rubbing alcohol and let them dry. Clean, rough surfaces are what make the new glue grip.
- Use a two-part epoxy that’s rated for metal and plastic (the slower-setting kind is stronger than 5-minute epoxy). Plain super glue or household glue won’t stand up to the pulling.
- Coat the post and the inside of the tube end, then slide the tube back on fully. Make sure the bar lines up straight with the left side.
- Hold it in place with painter’s tape and wipe off any glue that squeezes out. Let it cure for the full time on the package, usually 24 hours. Until then, open the drawer by gripping the top edge of the door, not the handle.
Done carefully, this usually holds for years. A steady pull instead of a yank helps it last.
If gluing doesn’t hold
If the end post is cracked, or the epoxy lets go again, replace the freezer handle. Samsung sells it as a part for this model, and it’s a cheap fix compared with the refrigerator itself, so it’s well worth doing even on a fridge this age. When it arrives, check whether the end caps are included. I’ve listed the part below. We’ll confirm the exact part number for your model so you get the right handle.
If anything looks different once you get in there, send a follow-up with a photo and I’ll help you sort it out.
— GIR Technician


