Hi Doug,
Cracked crisper drawers are one of the most common things to go on a fridge in the 8–12 year range. The plastic gets brittle, and one bump with a heavy bag is all it takes. Yes, you can replace them, and it’s a simple swap with no tools.
Finding the right drawers
Your Kenmore 253 model was built by Frigidaire, so the drawers are Frigidaire parts. That’s good news, because they’re widely available.
- The number you found: 242011502 looks like a Frigidaire part number molded into the plastic. The “CAV 1/2” next to it is just the mold cavity, not part of the number. Molded numbers sometimes belong to the raw plastic piece rather than the finished drawer, though. Always check it against your model number 253.70413411 before you order.
- The humidity drawer: pull it all the way out and look on the side walls and the bottom for a similar molded number. Also note whether it’s the left or right drawer. Frigidaire often uses a different part for each side, even when the two look the same. The slider on the humidity drawer is sometimes a separate part too.
- Before you order: measure the width, depth and height of each drawer. That helps confirm the match.
Swapping them out
- Empty the drawer and slide it out until it stops.
- Lift the front up slightly to clear the stops and pull it free.
- Slide the new drawer in on the same rails until it seats.
If a crack is small and the drawer isn’t load-bearing at that spot, clear packing tape on the outside will buy you some time. Cracks tend to spread, though, so replacement is the real fix. Rough cost is usually $40–$120 per drawer, depending on size.
I’ve listed both drawers below. We’ll confirm the exact part numbers for your model so you can check price and availability. Since you had the door gaskets on your list too, here’s the earlier Kenmore 253.70413411 gasket answer for reference. I’ve answered your cooktop clicking question separately.
If you find another number on the humidity drawer, send a follow-up and I’ll help you sort it out.

