Hi Russell, good call trying the unplug-and-restart first. That clears a lot of glitches, so since it didn’t help here, the fridge is most likely telling you something real.
What the “H1” probably means
On Frigidaire controls like the one in your FFHS2311LWD, what looks like “H1” is usually “HI”, the high-temperature warning. The control is saying the refrigerator side is warmer than it should be. That also explains why the setting won’t “stay”: the control keeps flashing the warning instead of showing your setting.
Check the temperature for real
Put a glass of water with a cheap fridge thermometer in the middle shelf and check it after a few hours. It should be about 37°F. If it reads in the mid-40s or higher, the warning is right, and here’s where I’d look:
- Is the freezer cold? On a side-by-side, all the cold air is made in the freezer and blown into the fridge side. If the freezer is cold but the fridge is warm, the air isn’t getting through.
- Frost on the freezer back wall. Take out the freezer shelves and look at the back panel. Heavy frost or ice there means the defrost system failed and the coil is iced over. A manual defrost (unplug with doors open for 24 hours, towels on the floor) will bring it back for a while, and then the defrost heater, thermostat or control needs checking.
- Freezer fan. Open the freezer door and press the door switch. You should hear and feel the fan blowing. No fan, no cold air to the fridge.
- Air damper. The damper between the two sides can stick closed, which leaves the freezer cold and the fridge warm.
If the fridge is actually cold and the light still flashes, then the control board or the fridge temperature sensor is the likely culprit. Let me know what the thermometer says and whether you see frost, and I’ll help you narrow it down from there.

