Hi McKenzie,
What a fun find, and a lot of work already done on it. If I'm reading you right, you got good flames, and then when you came back to test again the burners (or pilots) were out. On a range this old, that usually comes down to the pilot system, so that's where I'd start.
Safety first
If you ever smell gas, don't light anything or flip switches. Get everyone out and call your gas company from outside. After working on any gas fittings, brush soapy water on every joint you touched with the gas on. Bubbles mean a leak, so shut the gas off and retighten it before going further.
Things to check
- Standing pilots. Most ranges of this era have a small pilot flame under the cooktop that stays lit all the time and lights the burners through flash tubes. If the pilot went out, the burners won't light. Relight it, and if it keeps going out, the pilot flame is set too low or the tiny pilot opening is partly clogged. There's usually a small adjustment screw on the pilot line.
- Flash tubes. These are the metal channels running from the pilot to each burner. Make sure they're lined up with the burner ports and not bent or blocked by rust or debris.
- Gas type. If the range was converted between natural gas and propane, the orifices, the pilot, and the pressure regulator all have to match the gas you're using. A mismatch can give flames that look okay for a moment but won't stay stable.
- Air shutters. If flames lift off the burner or blow themselves out, close the air shutter a little until the flame is blue and sits on the burner.
Finding a manual
Look on the back of the range, under the cooktop, and behind the lower drawer for a paper sheet or wiring diagram, since old ranges often had one tucked in. Otherwise, searching the full number 103.249206 on parts-retailer sites and vintage stove groups is your best bet.
If the pilots keep going out or you aren't sure the conversion is complete, this is a good time to have a licensed gas technician check it. Gas valve and regulator work isn't a DIY job.
Tell me exactly what's happening now (pilots out, burners won't light, or flames go out while cooking) and I'll help you narrow it down. Just send a follow-up.

