Hi Dan,
Yes, your Samsung RF28HFEDTSR has a hidden forced defrost mode built into the control panel. It’s not in the owner’s manual because it’s really meant for service techs, but it’s safe to use and handy when you’re dealing with ice buildup behind the fridge or freezer back panel.
How to start a forced defrost
- Press and hold the Power Freeze and Fridge buttons together for about 8–10 seconds, until the display goes blank and the fridge chimes. (Samsung changed panel layouts over the years; if that pair does nothing, try Energy Saver and Fridge the same way.)
- Now you’re in test mode. Tap Power Freeze one press at a time. Each press steps to the next mode. The first is usually a forced cooling run (often shown as “FF”), the next is forced defrost (often shown as “Fd”).
- Stop on the defrost mode and leave it alone. After a few seconds it beeps and starts on its own. If your panel offers more than one defrost option, pick the one for the side that’s icing up.
A defrost cycle usually runs around 20–40 minutes. You may hear sizzling or dripping. That’s normal: it’s the heater melting frost off the coils. When it finishes, the fridge goes back to normal on its own. If you want to cancel it early, unplug the fridge for a minute and plug it back in.
When forced defrost isn’t enough
The heater only clears normal frost. If the coils are packed in solid ice, one cycle won’t get it all. In that case I’d do a manual defrost: empty the fridge, unplug it, and leave the doors open with towels down for 24 hours (a hair dryer on low aimed at the iced area speeds it up; just keep it away from plastic).
If the ice comes back within a few weeks, something is stopping the automatic defrost from working, like a weak defrost heater, a bad defrost sensor, or a blocked drain line. That’s worth fixing at the root rather than defrosting over and over.
Tell me what you’re seeing
If you let me know what led you to try a defrost (ice behind the back panel, water under the crispers, ice maker frozen up, fridge getting warm), I can help you narrow down which part is the problem. Just send a follow-up with what you’re seeing.
Hope that gets things back on track!

