Hi Stefan,
A fridge that keeps knocking out the main switch after a move is worth taking seriously,. Thanks for the photo of the label, too. It shows the model is an E522B. In Australia the switch that trips like this is almost always the safety switch (RCD). It cuts the power when some electricity is leaking to earth. With a fridge, that usually means moisture or damaged insulation somewhere in the wiring or in one of the heating parts.
Check these first
- Keep it unplugged at the wall while you check.
- Look over the power cord and plug. Moves often crush or pinch the cord behind the fridge or under a wheel. If you see a cut, a flattened section or scorch marks, don’t use it until the cord has been replaced.
- Plug it straight into a wall socket, not a power board or extension lead. Make sure the socket isn’t damp.
- Notice when it trips. If it trips the moment you plug it in, suspect the cord, wiring or compressor. If it runs fine for hours and then trips, the defrost heater is the prime suspect.
The most likely culprit: the defrost heater
Your label shows a 355 W defrost heater. Every so often it switches on to melt frost off the cooling coil behind the freezer panel. As these heaters age, water can get past the seals, so they leak a little current to earth and trip the RCD. It typically happens hours after the fridge was switched on, right when a defrost starts. An electrician or appliance tech can confirm it in minutes with an insulation-resistance test (a “megger”) on the heater and on the compressor.
If the heater is the fault, it’s a reasonable repair. The heater sits behind the freezer’s back panel, and the part usually costs somewhere around $60–$150 (a rough figure). I’ve listed the part below. You can check price and availability there, and we’ll match the exact part number to your E522B. If the test shows the compressor is leaking to earth instead, that’s sealed-system work for a technician only. On a fridge this age, it’s usually the point where replacing it makes more sense.
About its age
I can’t reliably decode a build date from that serial format. Fisher & Paykel’s customer care can tell you the manufacture date from the serial RAQ790158. Our repair-or-replace calculator can help you weigh it up once you have a quote.
Because this is an electrical fault, please have a licensed electrician or appliance tech do the testing. If you find out more, just send a follow-up and I’ll help you take the next step.
Cheers,
The GIR Technician


