Hi Paul,
A dishwasher with a dead touch panel is frustrating, because it gives you nothing to go on. On your Frigidaire Professional FPHD2491KF0 it usually comes down to a few things, and you can rule out the simple ones yourself.
Start with power and a reset
- Check the breaker and any wall switch. Many dishwashers are wired to a switch next to the sink (often beside the disposal switch) that gets bumped off. Also look for a tripped breaker or a GFCI outlet under the sink that needs resetting.
- Do a hard reset. Turn the dishwasher’s breaker off for about 5 minutes, then back on. A power surge can lock up the electronics, and this clears it.
- Try the panel the right way. Your model has hidden controls on the top edge of the door. Open the door, press a cycle and Start, then close the door firmly within a few seconds. If the door isn’t fully latched, the cycle won’t begin.
If the panel still won’t light at all
Then the dishwasher is either not getting power or the electronics have failed. With the breaker off, remove the lower kick panel and check the wiring junction box at the front right corner underneath. Loose or burnt wire nuts there are a common cause. If you’re comfortable with a multimeter, turn the power back on carefully and confirm about 120 volts at that box; if you’re not, this is a good point to have a technician check it.
If power is reaching the dishwasher but the panel stays dark, the most likely culprits are:
- Main control board – the most common failure on this generation of Frigidaire dishwashers. A board that gets power but shows no lights, even after a reset, points here.
- Touchpad (user interface) – if some lights come on but pressing Start does nothing, or only certain buttons respond, the touchpad or its ribbon cable is more likely. Unplug and reseat that ribbon cable first; a loose connection there is a free fix.
I’ve listed both parts below so you can check price and availability right there. As a rough idea, a control board often runs about $100–$250 and a touchpad roughly $50–$150, depending on the supplier.
Repair or replace?
This model is getting older, so if the board is the problem, weigh that cost against a new dishwasher. Our repair-or-replace calculator can help you decide. A similar dead-panel case on a different brand is covered here: KitchenAid dishwasher panel won’t light.
Let me know what you find at the junction box or after the reset, and I’ll help you narrow it down. Just send a follow-up.
– The GIR Technician

