Hi Terry, I can help with this one. When the broiler and all the burners work but bake doesn’t heat, the control board usually isn’t the first suspect. On your Kenmore 790.90112011 (790 means it was built by Frigidaire), the most common cause by far is a burned-out bake element.
Check the bake element first
- Look at it. With the oven off and cool, look at the bottom element. A blister, a split, a bulge or a burnt spot means it’s done.
- Test it if it looks fine. Turn off the breaker, take out the two screws at the back wall of the oven, pull the element forward a few inches and take the wires off. A good element reads roughly 15 to 40 ohms on a multimeter. No reading at all means it’s open and needs replacing, even if it looks perfect.
- Check the wire ends while you’re there. Burnt or loose terminals at the element are common on older ranges and can stop it heating too.
When it is the control
If the element tests good, the next suspect is the control’s bake relay, which sends power to the element. The broiler has its own relay, which is why one can work while the other doesn’t. Before buying a control, check that power reaches the element wires when bake is on (with care, or have a technician do it), because controls cost far more than elements. I wrote about a similar Kenmore 790 bake problem here.
About the age
The model number won’t give you a date. The serial number will. On Frigidaire-built ranges, the third character of the serial is usually the last digit of the year and the next two are the week. So VF517… would be week 17 of a year ending in 5. Your tag should be behind the drawer or on the frame by the oven door.
An element is an inexpensive part and an easy swap, so this is definitely worth fixing. If you test it and get a reading you’re unsure about, send it over and I’ll help.

