Hi there,
A washer that starts out fine and then starts banging, roaring and leaking is no fun. On an older LG front-loader like your WM2301HR, those three symptoms together often share one root cause, so let’s narrow it down before you spend money.
First, find where the water is coming from
Unplug the washer and turn off the water taps first. Then run a short cycle with towels on the floor and watch where the water shows up:
- Front, under the door: look around the rubber door boot (pull back the folds and check for tears or holes, especially at the bottom).
- Lower front corner: check the drain pump filter cap behind the small access panel. If it isn’t screwed in snug or the seal is worn, it will drip.
- Back of the washer: check the fill hoses and drain hose for cracks or loose ends.
- Underneath, toward the back center, and it gets worse on spin: this is the one to worry about. It usually means the rear tub seal is leaking.
Check the noise and the off-balance
With the washer empty and unplugged, open the door and spin the drum by hand. A grinding or rumbling sound is a bad sign. Then grab the top edge of the drum and lift it up and down. If you feel a clunk or noticeable play, the drum bearings are worn. On these machines the tub seal leaks first, water gets into the bearings, and they wear out, which causes the roar and wobble.
If the drum turns quietly with no play, the banging is more likely the suspension. Press down hard on the top of the tub through the door opening and let go. It should feel firm and come back slowly. If it bounces freely, the shock absorbers (dampers) are worn out. Also make sure it’s level and all four feet are locked down.
Repair or replace?
Here’s my honest take. Worn shock absorbers are a reasonable fix (rough parts cost around $30 to $70 for a set). A door boot or loose filter cap is also cheap. But if the bearings and tub seal are gone, that’s a big job: the whole washer has to come apart, and on many LG models the bearings come with a new outer tub. On a 12+ year old washer, that repair often costs close to what a new machine does, so I’d lean toward replacing it in that case. Our repair or replace tool can help you weigh it.
I’ve listed the parts for both possibilities below. Do the drum test first, it tells you which one you need.
Let me know what you find, and feel free to send a follow-up with what the drum test showed or where the leak is coming from.

