Hi Gary, you’ve actually given me the biggest clue already: it started once after the lid slammed shut. That points straight at the lid switch.
Your Kenmore 110 series is built by Whirlpool. On these top-loaders, the washer fills first, then checks the lid switch before it starts agitating. If the switch doesn’t register that the lid is closed, it just sits there full of water.
What to check
- The little tab on the lid. Underneath the lid there’s a plastic or metal tab (the striker) that pushes into a slot on the top of the washer. Make sure it isn’t broken, bent or loose.
- Try pressing it in by hand. With the washer filled and the cycle on, lift the lid and gently press into the slot where the tab goes with something non-metal, like a pencil eraser. If it starts agitating, you’ve found your problem.
- Listen for a click. When you close the lid, you should hear a light click from the switch. No click usually means the switch has worn out.
If it isn’t the lid switch
If the switch clicks and works but the washer just hums without agitating, the next suspect is the motor coupler (a cheap plastic and rubber part between the motor and the transmission) or the drive belt, depending on your exact version.
Good news: a lid switch is usually an inexpensive part, and many homeowners replace it themselves. Even at 12+ years old, it’s worth fixing. Hope that gets you washing again!

