Technician Answers

Kenmore 110.26901691 Washer Overfilled and Overflowed on a Small Load

Answered by GIR Technician, GIR Appliance Repair · November 2, 2026
❓ The question
Kenmore Washer Model 110.26901691 Age: Over 12 years

“Why did this washer fill to the top and overflow when it was set on small load and had 6 min left in wash cycle”

Why did my washer fill and overflow the tub when it was set on small load and 6 min left on wash cycle ?

Asked by Donna from TN · October 31, 2026
GIR Technician
GIR TechnicianAppliance technician · GIR Appliance Repair, The Woodlands, TX
✓ Technician answer

Hi Donna, an overflow is scary, I’m glad you caught it. Your Kenmore 110.26901691 is a Whirlpool-built top-loader, and when one of these keeps filling past where it should, it’s almost always one of two things: a water valve that won’t shut off, or a pressure system that never tells the washer the tub is full.

Test 1: is the water valve sticking open?

This is the easy one to check. Turn the washer off and unplug it, then watch the tub for 10 minutes or so. If water keeps trickling in with the power off, the water inlet valve is stuck open and needs replacing. Turn the faucets off behind the washer until it’s fixed, so it can’t flood again.

Test 2: the pressure hose and switch

If no water comes in while it’s unplugged, the washer is filling because it “thinks” the tub isn’t full yet. It judges that with a thin plastic hose that runs from the bottom of the tub up to a pressure switch in the control console.

  • Check that small hose. Look for a crack, a loose end, a kink, or water sitting in it. With the washer unplugged, pull it off the switch and blow through it gently toward the tub. It should be clear. Let it drain, dry it, and push it back on firmly.
  • If the hose is fine, the pressure switch itself is the likely culprit. It’s an inexpensive part, but buy it by your full model number, since Kenmore used several versions.

Why it happened near the end of the wash

A washer normally only fills at the start of the wash and rinse, so refilling with 6 minutes left points to a valve that leaked slowly through the cycle, or a switch that lost its “full” signal partway through. Test 1 tells you which.

Both repairs are worth doing on a washer like yours. If you run the two tests and want help reading the result, just send it over and I’ll walk you through the next step.

Still stuck, or is your situation different?Ask your own question and a technician will answer it for free.
💬 Ask a Follow-Up Question
(346) 625-4289Tap to Call · Same-Day