Hi there, a washer that keeps filling can flood a laundry room fast, so first: until it’s fixed, stay close while it runs, or turn the faucets off behind it between loads. The good news is that one simple test tells you which part is to blame on your LG WT7600HWA.
The unplug test
Start a cycle, and when the water should have stopped but keeps coming, pull the power plug.
- Water keeps running with the washer unplugged: the water inlet valve is stuck open. With no power, the valve should snap shut, so if water still flows, the valve itself has failed (often from grit or hard water). This is the most common cause.
- Water stops as soon as you unplug it: the valve is fine. The washer is being told to keep filling because it thinks the tub is still empty. That points to the water level sensor or the small air hose that connects it to the bottom of the tub.
If it’s the sensor side
Unplug the washer, lift the top lid section and look for the thin rubber hose running down from the sensor (near the back of the control area). Make sure it isn’t kinked, cracked, clogged with residue or popped off. Blowing gently through it clears it sometimes. If the hose is fine, the sensor is the part.
Also worth a quick look
Check that the drain hose isn’t pushed too far down the standpipe. If it is, it can siphon water out while the washer fills, and the washer just keeps adding more.
Both parts are reasonable repairs on a washer this age. I’ve listed the exact valve and sensor for your WT7600HWA below, with a note on which result from the test points to which one. If you try the test and aren’t sure what you saw, send a follow-up and I’ll help.

