Hi Donna,
Good news: a dryer that runs perfectly with a broken knob is one of the easiest fixes there is. Yes, you can replace it yourself, no tools needed, and it’s a cheap part.
Why the knob keeps coming off
The knob slides onto a D-shaped plastic shaft that sticks out of the control panel. Over the years the little sleeve inside the knob cracks or wears round, so it can’t grip the shaft anymore. That’s why it pops off or just spins when you turn it.
Before you order, take a quick look at the shaft itself. If it’s still in one piece with its flat side intact, all you need is a new knob. If the shaft is snapped off flush with the panel, the knob won’t help, because the shaft is part of the timer (or the temperature switch) behind the panel. That’s a bigger repair.
Which knob do you need?
Your HTDX100ED4WW has two knobs:
- The large cycle (timer) knob, the one you turn to pick the drying time or cycle. This is the one that breaks most often because it gets turned every load.
- The smaller selector knob for the heat setting. This one uses a knob-and-clip set.
I’ve listed the exact part for each knob on your model below. Just pick the one that broke, and you can check price and availability right there. Knobs like these usually run roughly $10 to $35.
How to put the new one on
- Turn the dryer off. If the old knob left a broken piece on the shaft, pull it straight off with your fingers or gently with pliers. Don’t twist hard.
- Line up the flat side inside the new knob with the flat side of the shaft.
- Push it straight on until it seats firmly. For the large knob, turn it to a cycle and make sure the pointer lines up with the markings.
Skip the glue. It can run into the timer and make the next repair much harder.
How old is your dryer?
On GE serial numbers, the first two letters give the build date. The first letter is the month and the second is the year. In MD710905C, M means July and D means 2014. So your dryer is about 12 years old. Since it still runs well, a $20 knob is money well spent.
If the shaft turns out to be broken or the new knob still won’t hold, send a follow-up with a photo and I’ll walk you through the next step.
Happy drying!
The GIR Technician


