Hi there,
That buzzer is relentless once it gets going, and unplugging it was exactly the right move. On older GE ranges like your JBP220F2WH, the clock/timer is a mechanical unit, and the minute-timer buzzer sounds whenever the timer thinks it has run down to zero. A bump that knocks the knob or the timer’s insides out of place can leave it stuck “at zero” and buzzing nonstop.
Try this first (no tools needed)
- With the range still unplugged, gently pull the timer knob straight off its shaft. These usually just press on.
- Look at the shaft and the knob. If the knob is cracked or slipping on the shaft, that alone can explain the loose indicators.
- Carefully try to turn the bare shaft (fingers or a small pair of pliers, light pressure only) back toward the off/zero position, or wind the minute timer a bit past zero.
- Plug it back in and listen. If it’s quiet and the clock runs, push the knob back on and you’re done.
If the shaft won’t turn, grinds, or the buzzing comes right back, don’t force it. Something inside the clock is broken.
Getting to the back of the timer
Always unplug the range (or shut off its breaker) before opening anything. On most GE freestanding ranges of this style, you reach the clock by sliding the range out (lift slightly so you don’t snag the anti-tip bracket on the back leg) and removing the screws on the rear cover of the backsplash. The clock is then held by a couple of screws or clips, with a small group of wires on the back. Take a photo of the wiring before you unplug anything. If any wires look scorched, brittle or melted, that’s worth fixing at the same time.
Fix it or live without it?
The real fix is a replacement clock/timer. Clocks for older GE models can be discontinued, so availability is the big question. I’ve listed it below. You can check price and availability right there, and we’ll match the exact part # to your model. As a rough idea, these clocks often run somewhere around $60–$180 when you can find them.
I wouldn’t just cut the buzzer wires yourself. On some of these ranges the clock also feeds the oven’s timed-bake circuit, and the wrong wire can leave the oven dead. If the clock can’t be found, a technician can often wire around it safely, or you can weigh replacing the range with our repair-or-replace tool.
If you get the back open and want a second set of eyes, send a follow-up with what you see. Good luck, and enjoy the quiet in the meantime!

