Technician Answers

GE GTD72EBPN0DG electric dryer runs but is not heating

Answered by GIR Technician, GIR Appliance Repair · November 20, 2026
❓ The question
GE Dryer Model GTD72EBPN0DG

“Why is my dryer not heating”

Asked by Monica from TX · November 20, 2026
GIR Technician
GIR TechnicianAppliance technician · GIR Appliance Repair, The Woodlands, TX
✓ Technician answer

Hi Monica,

A dryer that tumbles but stays cold is one of the most common calls we get. On your GE GTD72EBPN0DG (an electric model) the cause is usually simple and inexpensive. Here’s the order I’d check things in, easiest first.

Start with the easy checks

  1. Look at the breaker. An electric dryer runs on a double breaker. If just one half trips, the drum can still spin and the lights still come on, but you get no heat. Flip that breaker fully off, then back on.
  2. Check the cycle. Make sure it isn’t set to Air Fluff or a no-heat/low-temp setting.
  3. Clean the lint screen and the vent. Check the duct behind the dryer for kinks, and make sure air blows out hard at the outside vent hood. A clogged vent is the number one reason the heating parts burn out, so fix this even if it turns out not to be the main problem.

If it still won’t heat: the heater and its safety thermostat

If power and airflow are good, the problem is almost always on the heater assembly behind the drum. Unplug the dryer first (or shut off the breaker) before you take off any panels. With a multimeter on the ohms setting:

  • Heating element: test across its two terminals. A good element reads somewhere around 8–12 ohms. No reading (open) means the coil has broken, and that’s the part to replace. You can often see the break in the coil, too.
  • High-limit thermostat: it’s mounted on the heater housing and should show continuity (close to 0 ohms) at room temperature. If it’s open while the element tests fine, the thermostat is your culprit. These usually fail because the dryer overheated from a restricted vent, which is why that vent check matters.

Whichever part tests bad, I’ve listed the exact part for your model below — you can check price and availability right there. As a rough idea, these parts usually run from about $20 for a thermostat to $50–$90 for a heater assembly, so on a dryer like this, fixing it is almost always worth it over buying a new one. If you’re still deciding, our repair-or-replace tool can help.

If both test good, the next suspects are the other thermostats and the control’s heat circuit, which is a good point to call a technician. Similar case: this LG dryer that runs but won’t heat.

Let me know what you find

If you get readings you’re not sure about, or the breaker fixed it but it trips again, send a follow-up with what you saw and I’ll help you take it from there.

— The GIR Technician

🔧 Part needed
Heater and housing assembly
Part # WE11X21156 Fits GE GTD72EBPN0DG

If the heating element reads open (no continuity) on your multimeter.

High-limit thermostat
Part # WE04X30381 Fits GE GTD72EBPN0DG

If the element tests good but this thermostat is open at room temperature.

Want us to get this part for you? We source genuine parts through our supplier network. Send a quick request and we'll email you the current price and availability, usually within one business day. No obligation.
Still stuck, or is your situation different?Ask your own question and a technician will answer it for free.
💬 Ask a Follow-Up Question
(346) 625-4289Tap to Call · Same-Day