Hi Monica,
A dryer that tumbles but stays cold is one of the most common calls we get. On your GE GTD72EBPN0DG (an electric model) the cause is usually simple and inexpensive. Here’s the order I’d check things in, easiest first.
Start with the easy checks
- Look at the breaker. An electric dryer runs on a double breaker. If just one half trips, the drum can still spin and the lights still come on, but you get no heat. Flip that breaker fully off, then back on.
- Check the cycle. Make sure it isn’t set to Air Fluff or a no-heat/low-temp setting.
- Clean the lint screen and the vent. Check the duct behind the dryer for kinks, and make sure air blows out hard at the outside vent hood. A clogged vent is the number one reason the heating parts burn out, so fix this even if it turns out not to be the main problem.
If it still won’t heat: the heater and its safety thermostat
If power and airflow are good, the problem is almost always on the heater assembly behind the drum. Unplug the dryer first (or shut off the breaker) before you take off any panels. With a multimeter on the ohms setting:
- Heating element: test across its two terminals. A good element reads somewhere around 8–12 ohms. No reading (open) means the coil has broken, and that’s the part to replace. You can often see the break in the coil, too.
- High-limit thermostat: it’s mounted on the heater housing and should show continuity (close to 0 ohms) at room temperature. If it’s open while the element tests fine, the thermostat is your culprit. These usually fail because the dryer overheated from a restricted vent, which is why that vent check matters.
Whichever part tests bad, I’ve listed the exact part for your model below — you can check price and availability right there. As a rough idea, these parts usually run from about $20 for a thermostat to $50–$90 for a heater assembly, so on a dryer like this, fixing it is almost always worth it over buying a new one. If you’re still deciding, our repair-or-replace tool can help.
If both test good, the next suspects are the other thermostats and the control’s heat circuit, which is a good point to call a technician. Similar case: this LG dryer that runs but won’t heat.
Let me know what you find
If you get readings you’re not sure about, or the breaker fixed it but it trips again, send a follow-up with what you saw and I’ll help you take it from there.
— The GIR Technician

