Hi Alfonso,
Switching a gas range over to propane is a common job, and you’re right to get the proper kit instead of drilling or guessing at orifices. Here’s what I’d do for your Frigidaire GCRG3060ADB.
Check if the kit came with the range first
Many Frigidaire gas ranges ship with the LP orifices already included, so before you buy anything I’d look in these spots:
- A small bag taped or clipped to the back of the range, often near the gas pressure regulator.
- The literature packet (owner’s guide and installation instructions), sometimes in the storage drawer.
- The installation instructions themselves. They have a section on LP conversion that lists what’s needed and the orifice sizes for each burner.
If the range was bought used or that bag is long gone, you’ll need a replacement kit. The parts diagram I can see for your model lists the natural gas top burner ignitor/orifice assemblies (each burner has its own size: 18K, 14K, 9.5K and 5K), but it doesn’t show the LP kit as a separate item. So I won’t guess a number. I’ve listed the LP conversion kit below, and we’ll match the exact part # to your model.
What the conversion involves
- Turn off the gas supply and unplug the range.
- Switch the pressure regulator to LP. On most Frigidaire regulators you unscrew the cap and flip the insert so the LP side faces the right way. The instructions show which way.
- Change the top burner orifices to the LP sizes for each burner position. Keep the natural gas ones in a bag in case you ever move.
- Adjust the oven bake and broil burner orifices for LP (on many models this means turning the orifice hood down snug, not swapping it).
- Set the low flame on each top burner valve so it doesn’t go out when turned down.
- Turn the gas back on and check every fitting you touched with soapy water. Bubbles mean a leak.
Flames on LP should be steady and mostly blue with small inner cones. Big yellow, lazy flames or soot usually mean an orifice was missed or the regulator is still set for natural gas.
A word on safety
Because you’re working with gas lines and fittings, I’d strongly suggest having a licensed gas installer do the conversion or at least check it afterward. If you ever smell gas, don’t use any switches or flames. Leave the house and call your gas supplier from outside.
If you find the kit bag but aren’t sure it’s the right one, or want help reading the conversion steps, just send a follow-up with a photo of the bag label or the model/serial tag.
Good luck with the install!

