Hi Margaret, a washer that suddenly stops draining is usually caused by something blocking the water’s way out, not a big repair. Here’s what I’d check first.
If it’s a top-loader
- The drain hose. Pull the washer out a bit and make sure the hose isn’t kinked or flattened behind it. If it goes into a pipe in the wall, check that it isn’t pushed in too far or plugged.
- Something stuck in the pump. Small socks and baby clothes can slip past the tub and lodge in the drain pump. If you hear the pump humming during the drain but no water moves, that’s very likely it.
- The lid switch. On many GE top-loaders, the washer won’t drain or spin if it doesn’t sense the lid is shut. If it stops at the drain step and is very quiet, check that the lid closes firmly.
If it’s a front-loader
- Look for a small access door at the bottom front. Behind it is a drain pump filter. Put down towels and a pan, drain the water slowly, and clean the filter. That fixes a lot of front-loaders.
When it’s a part
If there’s no clog and you can’t hear the pump at all when it should drain, the drain pump has probably failed. At 8–12 years old, a drain pump is usually a reasonable repair.
To get the water out in the meantime, lower the end of the drain hose into a bucket on the floor and let gravity do the work. If you can send us the model number (it’s on a label under the lid or on the back), we can point you to the exact parts. Hope this helps, Margaret!

