Hi Patty, the fact that the drum light comes on is actually useful: it tells us power is reaching the dryer and the door switch is doing its job. So the problem is somewhere between the buttons and the control that reads them. Before you spend any money, here’s what I’d try, in this order.
1. Make sure Control Lock isn’t on
Your Kenmore 110 (made by Whirlpool) has a Control Lock feature, usually shared with another button and marked with a little lock icon. Press and hold that button for about 3 seconds. It’s easy to turn on by accident while wiping the panel, and when it’s on the buttons simply do nothing.
2. Check both halves of the breaker
A dryer runs on a double breaker. If only one half has tripped, you can still get the light but the controls may act dead. Flip the dryer breaker fully off, then back on, even if it looks fine.
3. Do a longer reset
Ten seconds often isn’t enough for these electronic controls. Unplug the dryer (or leave the breaker off) for a full 5 minutes, then try again.
If it’s still unresponsive
At this point it’s usually one of two parts: the touchpad/console (user interface), where the buttons wear out or the ribbon cable works loose, or the main electronic control board behind it. A tech checks the ribbon connector and whether the board is getting power before replacing anything, because these parts aren’t cheap. On a dryer that’s 12+ years old, it’s worth getting a price on the part first and weighing it against a newer dryer; our repair or replace calculator can help with that.
Let me know how the Control Lock and reset go. If none of it helps, send a follow-up with a photo of the control panel and I’ll help you narrow it down.

