Technician Answers

Kenmore 110 Dryer Spins Empty but Not With Clothes After a New Belt

Answered by GIR Technician, GIR Appliance Repair · October 28, 2026
❓ The question
Kenmore Dryer Model 11060222511 Age: 8–12 years

“Why does my dryer not spin?”

Thursday 10/22/26 I was drying a load of clothes when I heard a snap and then bang. My dryer had quit working. I found that the drive belt had broken, therefore releasing the pressure on the tensioner which let go and hit the inside of the cabinet. I ordered and replaced the drive belt PN#341241 which was specified as the replacement. After I installed the new belt and reassembled the dryer, I tried to dry a load of clothes. The drum would spin fine empty, when I put a normal load of clothes in to dry, it wouldn't spin. Can you help me figure out what next to try?

Asked by Roger from VT · October 27, 2026
GIR Technician
GIR TechnicianAppliance technician · GIR Appliance Repair, The Woodlands, TX
✓ Technician answer

Hi Roger, nice work tracking down the broken belt and replacing it yourself! You’re very close. When the drum turns fine empty but stops with clothes in it, the belt is slipping. That almost always means it doesn’t have enough tension.

Your Kenmore 110.60222511 is built by Whirlpool, and the 341241 belt is the right one. Here’s what I’d check, in order:

1. How the belt goes around the idler pulley

This is the most common thing to get wrong on these dryers, so don’t feel bad if that’s it. The belt goes around the motor pulley and the idler (tension) pulley in a backward “S” or “Z” shape: the belt passes over the idler pulley first, then goes back around the motor pulley. If it’s just looped around the motor pulley, it’ll spin empty but slip with a load. A diagram is usually on the back of the dryer or on the parts sites.

2. The idler pulley and its spring

You said the tensioner snapped back and hit the cabinet when the belt broke. That sudden hit can stretch or break its spring, or bend the arm. Check that the spring is still attached at both ends and that the arm pulls the belt tight. If the spring looks loose or stretched, replace the idler assembly. It’s not expensive.

3. The pulley wheel itself

Spin the idler pulley by hand. It should turn freely and smoothly. If it sticks or wobbles, replace it.

4. Drum rollers

If all of that looks good, turn the drum by hand with the belt off. If it feels heavy or rough, worn drum rollers could be dragging, which is common at 8–12 years.

My money is on #1 or #2. You’ve got this, Roger!

Still stuck, or is your situation different?Ask your own question and a technician will answer it for free.
💬 Ask a Follow-Up Question
(346) 625-4289Tap to Call · Same-Day