Hi Peg, the clue that helps most is that a separate Rinse & Spin works. That means the motor and the drum can spin just fine, so something is stopping the regular cycle before it gets to the final spin. Your Kenmore 796 was built by LG, and on these there are three usual reasons.
1. The PF code: power was interrupted
PF means “power failure”: the washer lost power for a moment during the cycle. When that happens it can stop or restart part of the cycle and skip the final spin. Make sure it’s plugged straight into the wall (no extension cord or power strip), the plug fits snugly, and nothing else on that circuit (a space heater, a dryer on the same outlet) is tripping it. If you see PF often, a loose outlet is a very common cause.
2. A partly clogged drain filter
At the bottom front, behind a small door, there’s a round pump filter with a little drain hose next to it. Put a shallow pan and towels down, drain the hose, then unscrew the filter. Coins, hair ties and lint in there make the water drain too slowly, and the washer won’t spin fast while there’s still water in the drum. Also check that the drain hose isn’t kinked or pushed too far down the standpipe.
3. An unbalanced load
If the load bunches to one side (a single bath mat, sheets wrapped around towels), the washer tries to rebalance and then gives up on the high-speed spin. A mixed, medium-size load usually fixes that.
If the filter is clean but it still drains slowly
Then the drain pump itself is getting weak. You’ll often hear it hum or run without moving much water. It’s one of the easier parts to swap on these washers, and I’ve listed it below so you can check the price for your exact model.
Start with the outlet and the filter, since those fix most of these. Let me know what you find in the filter.

