Hi there, sorry your washer quit on you. The good news first: a front-loader that won’t drain is one of the most fixable problems there is, and on your Kenmore 796.41482411 it’s very often something you can clear yourself in half an hour.
Your model starts with 796, which means it was built by LG. That matters, because LG-made washers all drain the same way, through a pump at the bottom front with a small filter in front of it.
Start with the drain pump filter
- Find the little door at the bottom front corner of the washer, below the door. Behind it there’s a short drain tube and a round cap you unscrew by hand.
- Put down towels and a shallow pan first. Since the tub didn’t drain, there’s water waiting. Pull the little tube out, take the cap off it and let the water run out slowly into the pan.
- Then unscrew the big round filter cap. This is where socks, coins, hair ties, bra wires and lint end up. Clean it out, look inside the opening for anything stuck in the pump blades, and screw it back tight.
Run a “Rinse + Spin” afterwards. If it drains now, that was it.
If it still won’t drain
- Check the drain hose behind the washer. It should not be kinked, crushed against the wall or pushed too far down the standpipe.
- Listen during the drain. If you hear the pump humming but no water moves, something is still jammed in it or the hose. If you hear nothing at all, the pump motor itself has likely failed.
- Look at the display. An “OE” code on these LG-built machines means a drain problem, which confirms you’re looking in the right place.
Is it worth fixing?
At 8 to 12 years old, yes, in most cases. A new drain pump is a modest part and a straightforward repair. I’d only think about replacing the washer if it also has a bad bearing (a loud roar on spin) or a leaking tub.
If you try the filter and it still won’t drain, send me what you hear when it tries, and I’ll help you narrow it down.

