Hi Suzy, a washer stuck in the rinse that won’t drain or spin is one of the most common problems we see. Very often it’s something you can fix yourself.
The “796” at the start of your model number means your Kenmore front-loader was built by LG.
1. Clean the drain pump filter (do this first)
At the bottom front corner of the washer there’s a small access door. Behind it is a filter that catches coins, hair ties, socks and lint. When it clogs, the water can’t get out and the washer stops in rinse.
- Put down plenty of towels and a shallow pan. A full washer holds a lot of water.
- Pull out the small drain tube (if there is one) and drain the water into the pan first.
- Then twist the filter out slowly, clean it, and look inside for anything stuck in the pump.
2. Check the drain hose
Make sure the hose behind the washer isn’t kinked or squashed, especially if the washer was moved recently. If it goes into a standpipe, make sure it isn’t pushed in too far.
3. Listen to the pump
After you clean the filter, run a Drain/Spin cycle. If you hear the pump hum but no water moves, something is still stuck in it. If you hear nothing at all, the drain pump itself may have failed. That’s a fairly common and reasonable repair on these washers.
Also keep an eye on the display for an error code like OE. That one means it’s a drain problem. Start with the filter, I’d bet that’s where you’ll find it. Good luck!

