Hi Debra, yes, this is usually repairable, and the fact that the water drained is good news: the pump works. Your Kenmore Oasis was built by Whirlpool, and when one of these drains but won’t spin, it’s most often one of a few things. We’re based in Houston, so we can’t come out to Central Point, but here’s how to narrow it down yourself so you know what you’re dealing with.
1. Try a Drain & Spin and watch the lid
Run just a Drain & Spin with the lid closed. Within a few seconds you should hear a click as the lid locks, and the Lid Locked light should come on. The Oasis won’t spin unless it’s sure the lid is locked.
- No click, or the light flashes: the lid lock assembly is the likely problem. Also check the lid itself: a cracked lid or a bent striker (the little tab on the lid) can stop it from locking.
- It locks and spins fine: the last load was probably unbalanced. Heavy items like a single comforter or wet towels bunched to one side make these washers stop spinning.
2. Write down the code next time
If it stops again, look at the display before you open the lid. A code there points straight to the cause, and it saves you from replacing the wrong part.
If it locks but still won’t spin
Then it’s usually the shift actuator (the part that switches the washer between agitating and spinning) or, less often, the motor control. Those are a step up in work.
On an Oasis this age, a lid lock is a sensible repair. A motor control or a major part is when I’d compare the cost against a newer washer. I’ve listed the lid lock below in case your test points to it. Send a follow-up with what happens on the Drain & Spin and I’ll help with the next step.

