Hi Megan, sorry you’re dealing with this, but the suds and the bit of water on the floor tell the whole story. On Whirlpool dishwashers F8 E4 means the flood (leak) sensor has been triggered. Too many suds foamed up, some water escaped into the base pan under the tub, and a little float in there lifted and told the dishwasher to stop and pump out for safety.
Why the code is still showing
Turning it off and letting it dry is the right idea, but the water sits in a tray hidden under the machine, so it can take a long time to evaporate. Until that tray is dry, the float stays up and the code comes back.
What to do
- Switch it off at the wall and leave the door open.
- Give it a good 24–48 hours to dry out completely. A fan pointed at the kickplate area speeds this up.
- Get rid of the suds source: use only proper dishwasher tablets or powder (never hand dish liquid), and if anything was pre-rinsed with dish soap, rinse it well first. If there’s still foam in the tub, add a splash of milk or a few drops of vegetable oil and run a short rinse; it knocks suds down.
- Power it back on and run a rinse-only cycle while you watch underneath for drips.
When to call for service
Your dishwasher is less than a year old, so if the code comes back with no suds involved, or you see water under it again, please don’t open it up. Contact Whirlpool Australia for a warranty visit, since it’s most likely a door seal or hose connection that they’ll fix at no cost.
I hope it’s just the suds and it’s back to normal after it dries. If you still get the code, send a follow-up and let me know what happens on the rinse cycle.

