Hi Richard, thanks for sending the photo of the display, it helps a lot. The code is 3E, not sd, and that changes the picture. 3E on a Samsung washer means a motor problem: the control tried to turn the drum and didn’t get the right signal back from the motor. “Sometimes it works and sometimes not” fits that very well.
About the water in the filter
The little door at the bottom right is the drain pump filter. When the washer stops with a 3E, it often stops with water still in the drum, so a lot of water coming out there is expected. While you have it open, clean out the filter, because lint and coins there cause their own problems.
What to check, step by step
- Turn the drum by hand with the washer unplugged and empty. It should turn smoothly and quietly. If it’s stiff, scrapes or something is stuck between the drum and the tub (an underwire from a bra is a classic), that alone can cause 3E.
- Don’t overload it. A very heavy or tangled load can make the motor struggle at the start.
- Look at the back. Many Samsung washers of this generation have a belt from the motor to the drum. Take the back panel off and check that the belt is on and not cracked.
- Check the carbon brushes. These washers usually have a motor with two small carbon brushes, one on each side. As they wear down, the motor starts some times and not others, which is exactly what you describe. If they’re short or chipped, a new pair is an inexpensive fix.
- Check the motor plug for a loose or burnt connection while you’re there.
If the drum turns freely, the brushes are fine and the plug is good, the next suspects are the motor’s speed sensor or the control board, and that’s when I’d weigh the cost against the washer’s age.
The serial number
Your serial isn’t in the US format, which is why our tool couldn’t read it. For this problem, though, the age matters less than the test above.
About the water not coming in at the start: if that keeps happening once the 3E is fixed, check that the tap is fully open and clean the little mesh screen where the hose connects to the washer. I’ve listed the brushes below. Send a follow-up with what you find and I’ll help with the next step.


