Hi Lilly,
That sounds frustrating, especially after waiting months. You’re right that a mixed set will never sit level. The good news is that your Hotpoint RAS200DM3WW has a short, clear factory parts list, so you can hand your superintendent the exact part numbers.
What your range takes
Your 20″ range has four burners: one 8″ and three 6″. The factory parts list for your model shows:
- 6″ drip bowl (chrome): WB31K10265 (you need 3)
- 8″ drip bowl (chrome): WB31K10266 (you need 1)
- 6″ surface burner with sensor: WB31X46067 (you need 3)
- 8″ surface burner with sensor: WB31X46066 (you need 1)
The “center points” you noticed on your original coils are the temperature sensors. Your range was built with sensor burners, so I’d go back to the factory sensor burners rather than keep a mix of other coils. They’re what the range was designed and safety-tested with.
Why they bounce and won’t sit level
- Wrong or bent bowl. If a bowl isn’t the right one or has been bent, the burner sits crooked. Hammering it straight rarely brings it back flat. Bent bowls should be replaced.
- Burner not fully plugged in. With the burner off and cool, the two prongs should push all the way into the plug-in socket, and the burner should rest flat on its support. If it only goes in partway, the bowl’s hole may be the wrong size or bent.
- Mixed burners. Coils from different makers can have slightly different legs and heights, so even the right bowls won’t fix a mismatched burner.
Before anyone pulls burners or bowls out, the burners should be off and completely cool.
What to tell the superintendent
Ask for a matched set ordered by the model number RAS200DM3WW, using the four part numbers above. That’s far easier than measuring, because sizes measured at home are often a little off. On porcelain: the factory list for your model only shows chrome bowls. If they want porcelain, they should only order bowls sold as a fit for your exact model number and check that they match the chrome ones in size and in the cutout for the plug.
If anything still sits crooked after the new set is in, send a follow-up and tell me which burner it is. I’m happy to help you sort it out.
— GIR Technician

