Technician Answers

Whirlpool 23832100 washer won’t advance through drain, rinse and spin on its own

Answered by GIR Technician, GIR Appliance Repair · November 15, 2026
❓ The question
Whirlpool Washer Model 23832100 Age: Over 12 years

“why it's not cycling properly”

doesn't stop between cycles and has to be set manually to drain wash cycle, rinse cycle and then final spin

Asked by A homeowner from TN · November 15, 2026
GIR Technician
GIR TechnicianAppliance technician · GIR Appliance Repair, The Woodlands, TX
✓ Technician answer

Hi there,

Having to babysit the washer and turn the knob yourself for every step gets old fast. The good news is that this symptom usually points to one of two parts, and you can narrow it down with a simple test.

One quick note on the model: 23832100 looks like the part after the dot of a Kenmore 110 number. If your label actually reads 110.23832100, it’s a Whirlpool-built Kenmore, so the advice below still applies. The model/serial tag is usually under the lid or on the back of the console. Send it over if you want me to double-check.

Watch the dial during one load

On these washers the cycle knob is moved by a small motor inside the timer, so the knob should slowly creep forward on its own while the machine runs. Start a normal cycle and check it every few minutes:

  1. The tub fills to the right level, it agitates, but the knob never moves. That’s the classic sign of a failed timer (the timer motor or its contacts). On a machine that’s 12+ years old, this is the most common cause.
  2. The knob stops during the fill and it either keeps filling or just sits there with a full tub. On many of these models the timer only advances once the water level pressure switch sees a full tub. Unplug the washer, remove the console’s back cover, and check the thin clear hose running from the switch down to the tub. If it’s cracked, kinked, loose or has water or gunk in it, clean it out or replace it. If the hose is fine, the switch itself is likely bad.

Also, when you turn it to drain by hand, does it pump out normally? If it does, your drain pump and hoses are OK and the problem is just that the cycle isn’t moving forward.

Parts and whether it’s worth it

A pressure switch is a cheap fix (very roughly $20–50). A timer costs more (very roughly $80–150), and you’ll want the exact number printed on the old one. I’ve listed both parts below. Once we have your full model number we can match the exact one so you can check price and availability right there. Always unplug the washer before you open the console.

Given the age, if it’s a timer and the washer has other problems too (leaks, noisy spin), try our repair or replace calculator before you spend money. Otherwise, these simple machines are usually worth fixing. For drain trouble on a similar model, see this answer.

Let me know what the dial does, and send your full model number with a follow-up.

🔧 Part needed
Washer timer
Fits Whirlpool 23832100

If the tub fills and agitates but the dial never moves on its own. We'll match the exact part # to your 23832100.

Water level pressure switch
Fits Whirlpool 23832100

If the dial stalls during the fill and the air hose is clear. We'll match the exact part # to your 23832100.

Want us to get this part for you? We source genuine parts through our supplier network. Send a quick request and we'll email you the current price and availability, usually within one business day. No obligation.
Still stuck, or is your situation different?Ask your own question and a technician will answer it for free.
💬 Ask a Follow-Up Question
(346) 625-4289Tap to Call · Same-Day