Hi Megan,
Thanks for drying it out and testing it the way I suggested in my earlier answer about the F8 E4 code. That result actually tells us a lot. If it was only leftover suds, the code would have stayed gone once the base dried. Coming back an hour after a clean cycle, with nothing on the floor, points to a small leak inside the machine that drips into the base tray slowly and lifts the flood float again after the cycle is over.
What usually causes this
- A slow drip inside the cabinet, from a hose connection, the pump or sump seal, or the water inlet valve. These leak into the base tray, not onto your floor, so you never see it.
- Water getting past the door, from the door seal or the lower door gasket. This often shows up as a trickle at the bottom corners.
- Rinse aid overflowing. If the rinse aid dispenser was overfilled or its cap isn’t sealing, it can foam and slip a little water past the door.
Quick checks you can do without opening it up
- When the code comes back, write down exactly what’s on the display and what time it is compared to the end of the cycle. If it’s a different code from F8 E4, that changes the diagnosis.
- Check the rinse aid cap is fully closed and wipe up any spilled rinse aid around it.
- After a cycle, run a dry paper towel along the bottom edge of the door and the lower corners of the tub. Damp towel = door seal area.
- Take a short phone video of the display and a couple of photos of the door seal. They’ll be useful for the warranty visit.
Let Whirlpool’s warranty handle it
Since your dishwasher is under a year old and the fault keeps coming back, I agree with you: something needs fixing, and it should be fixed under warranty. Please don’t take off the kickplate or panels yourself. Tracking down a slow internal leak is a job for the warranty technician. Contact Whirlpool Australia, give them your model (WDFS3R4NBSAU) and serial number from the label on the edge of the door, and tell them it’s an intermittent flood sensor fault that keeps returning with no suds present after a full dry-out.
Until then, keep the tap under the sink turned off between loads if you can. It’s a cheap way to stop any slow leak from the inlet valve.
If the technician finds something, or you’d like help reading what they tell you, feel free to send a follow-up. Good luck, and I hope it’s an easy fix!

