Technician Answers

Whirlpool dishwasher beeping F8 E4 after suds and water underneath

Answered by GIR Technician, GIR Appliance Repair · November 4, 2026
❓ The question
Whirlpool Dishwasher Model WDFS3R4NBSAU Error F8, E4 Age: Under 1 year

“My dishwasher keeps beeping with error codes F8 and E4”

It started Sunday night when the dishwasher started beeping with the error codes. There were a heap of suds in the bottom of the dishwasher and a little bit of water underneath the dishwasher. I've turned it off and let it dry out however when I turn it on the error message is still showing.

Asked by Megan · November 2, 2026
GIR Technician
GIR TechnicianAppliance technician · GIR Appliance Repair, The Woodlands, TX
✓ Technician answer

Hi Megan, sorry you’re dealing with this, but the suds and the bit of water on the floor tell the whole story. On Whirlpool dishwashers F8 E4 means the flood (leak) sensor has been triggered. Too many suds foamed up, some water escaped into the base pan under the tub, and a little float in there lifted and told the dishwasher to stop and pump out for safety.

Why the code is still showing

Turning it off and letting it dry is the right idea, but the water sits in a tray hidden under the machine, so it can take a long time to evaporate. Until that tray is dry, the float stays up and the code comes back.

What to do

  1. Switch it off at the wall and leave the door open.
  2. Give it a good 24–48 hours to dry out completely. A fan pointed at the kickplate area speeds this up.
  3. Get rid of the suds source: use only proper dishwasher tablets or powder (never hand dish liquid), and if anything was pre-rinsed with dish soap, rinse it well first. If there’s still foam in the tub, add a splash of milk or a few drops of vegetable oil and run a short rinse; it knocks suds down.
  4. Power it back on and run a rinse-only cycle while you watch underneath for drips.

When to call for service

Your dishwasher is less than a year old, so if the code comes back with no suds involved, or you see water under it again, please don’t open it up. Contact Whirlpool Australia for a warranty visit, since it’s most likely a door seal or hose connection that they’ll fix at no cost.

I hope it’s just the suds and it’s back to normal after it dries. If you still get the code, send a follow-up and let me know what happens on the rinse cycle.

Still stuck, or is your situation different?Ask your own question and a technician will answer it for free.
💬 Ask a Follow-Up Question
(346) 625-4289Tap to Call · Same-Day