Technician Answers

Bosch SHE3AR72UC dishwasher not heating water and E11 after replacing the heat pump

Answered by GIR Technician, GIR Appliance Repair · November 16, 2026
❓ The question
Bosch Dishwasher Model SHE3AR72UC/22 Error E11 Age: 8–12 years

“Water does not get hot enough to dissolve the detergent pod even though the pump/heater was just replaced”

Bosch Dishwasher photo 1 from the question
Asked by A homeowner from MI · November 16, 2026
GIR Technician
GIR TechnicianAppliance technician · GIR Appliance Repair, The Woodlands, TX
✓ Technician answer

Hi there,

That’s frustrating after putting in a new heat pump. Your label shows a Bosch SHE3AR72UC/22 (300 Series) with FD 9707, so it was built in July 2017. Before you open anything up, unplug the dishwasher or switch off its breaker.

Quick checks first

  1. Run the kitchen hot tap until it’s hot before you start a cycle. Starting cold, a short cycle may never get hot enough for a pod.
  2. Use Heavy or Auto with Sanitize for a test load.
  3. Put the pod in the dispenser and close the lid. Make sure nothing tall blocks its door from opening.
  4. Put the filter back in. In your sump photo the round cylinder filter is out. Clean it, then twist it in until the arrows line up. Without steady water flow, the pump’s built-in pressure switch won’t let the heater turn on.

Since the pump was just replaced

The Bosch heat pump has two separate plugs, one for the motor and a smaller one for the heater. If the motor plug went on but the heater plug is loose, sitting halfway, or has a corroded pin, you’ll get exactly what you’re seeing: it washes fine but stays lukewarm. With the power off, take off the kick plate and push both connectors on until they click. Look for pinched or scorched wires.

About the E11: I’d rather not guess its exact meaning from a generic chart. Write down when it shows up (start, middle, or end of the cycle).

If the connections are good

If the plugs are solid and a mid-cycle check still shows lukewarm water (carefully open the door about 20 minutes into a Heavy cycle), the next most likely part is the control module (power board). A failed heater relay is a known problem on boards this age. With the power off, test the new pump’s heater terminals for continuity with a meter. If the heater is fine, the board is the part to replace. I’ve added it below, and you can check price and availability right there.

A board usually costs roughly $150–$300, and the unit is about nine years old with a new pump already in it, so it’s normally worth fixing. Our repair-or-replace calculator can help you decide. If it’s not drying well either, that’s the same heat problem. See this answer for your exact model.

Let me know what the connectors look like and when E11 appears. You can send a follow-up anytime and I’ll help you narrow it down.

🔧 Part needed
Control module (power board)
Fits Bosch SHE3AR72UC/22

If both pump plugs are secure and the heater checks good but the water stays lukewarm. We'll match the exact part # to your SHE3AR72UC/22.

Want us to get this part for you? We source genuine parts through our supplier network. Send a quick request and we'll email you the current price and availability, usually within one business day. No obligation.
Still stuck, or is your situation different?Ask your own question and a technician will answer it for free.
💬 Ask a Follow-Up Question
(346) 625-4289Tap to Call · Same-Day