Hi Ann, thanks for the clear description, it actually points right at the cause. When your Samsung shows the unbalanced code with only water in the drum, the load isn’t the problem. The washer can’t pump the water out, so the drum stays heavy, it can’t get up to spin speed, and the control reads that as “unbalanced”. So we’re looking at a drain problem, not a balance problem.
What I’d check first (free)
- Clean the drain pump filter. On your WF50K it’s behind the small door at the bottom front corner. Put down towels and a shallow pan, pull out the little black drain hose, let the water run out, then unscrew the filter cap. Coins, hair ties, bra wires and baby socks love to hide there. Rinse it, screw it back in snug.
- Check the drain hose. Make sure it isn’t kinked behind the washer and isn’t pushed more than about 6–8 inches down into the standpipe. If the standpipe is slow, the house drain may be the real clog.
- Run Drain/Spin by itself and listen near the bottom front. A steady hum but no water moving usually means something is jammed in the pump or the impeller is broken. No sound at all means the pump motor itself has likely failed.
If the filter and hose are clear
At 8–12 years old, the drain pump is the most likely part to have worn out, and it fits the “started two days ago” story perfectly. On this model it’s a moderate DIY job: unplug the washer, drain the last of the water through the filter hose, then the pump comes out with a few screws, two hose clamps and one wire plug. Plan on about an hour. I’ve listed the exact part for your model below.
One more note: if it drains fine after cleaning the filter but still throws UB on normal loads, the shock absorbers are the next thing to look at. Let me know and I’ll walk you through that too.
Hope this gets you back up and running. If anything looks different from what I described, send a follow-up with a photo and I’ll take a look.

