Hi Steve, a loud high-pitched squeal right when your washer goes into spin is one of the most common sounds on this Whirlpool, and the good news is it’s usually the cheapest fix. Quick note first: the model you entered (WRW50000DW1) looks like a small typo for WTW5000DW1. Please double-check the tag under the lid, because that’s the model I’m answering for.
Most likely cause: the drive belt
Your washer uses a rubber belt between the motor and the transmission. After 8–12 years that belt gets glazed, stretched or cracked, and when spin starts and the load gets heavy, it slips on the pulley and squeals. It’s often loudest at the start of spin and can come with a faint burnt-rubber smell.
How to check it yourself
- Unplug the washer and turn off the water.
- With the tub empty, tip the washer back against a wall (a helper makes this easy) so you can see underneath.
- Look at the belt: shiny, cracked, frayed or loose means it’s done. You should not be able to twist it much more than a quarter turn.
- While you’re there, spin the motor pulley by hand. It should turn smoothly and quietly. If it grinds or feels rough, the motor bearings are the problem instead.
- Back on its feet, turn the empty basket by hand. A smooth, quiet turn with some resistance is normal. Scraping or a dragging feel points to the transmission (gearcase), which is a bigger repair.
If it’s the belt
Replacing it is very doable from underneath with the washer tipped back: the old belt comes off the motor and transmission pulleys, and the new one goes on the same way. Plan on about 30 minutes with basic tools. I’ve listed the exact belt for your model below.
If the belt looks new and the squeal is still there, send a follow-up and tell me exactly when the noise starts and stops, or attach a short video. That helps me pin it down quickly.

